User Manual

160
User Manual
When designing the system, remember to take into account the insertion loss
of the TBSI.
Warnings
The overall input power must not exceed +30dBm
TBSI Installation
Since the TBSI module doesn’t require any power supply it can be housed
either in an active or a passive TPRN sub-rack.
1. Unpack the kit which include
 1 TBSI
 2 RF jumpers (SMA-m), 1 x 35cm, 1 x 45cm
2. Carefully insert the TBSI module in any of the TPRN sub-rack slots and
lock the 4 screws on the front corners.
3. Connect RF cables according to what planned by designer. Use a specific
torque wrench to fix each cable to relevant ports.
4. Set proper attenuation values.
TBSI