User's Manual

178
ION-B User Manual
confi guration through LMT Software and/or remote supervision system.
For more details on how to use the LMT and about TSUNx confi guration and start-up refer to
their relevant manuals.
• in case the system is not working properly, refer to the troubleshooting procedures reported
in their relevant sections.
start
end
Mount the
Rack into the
cabinet
Insert all the boards
into the proper Rack,
according to the
system design)
Are there any
other Racks?
Connect the
power cables
Set the Rack baud rate (the
same for all the Racks - see
Fig. 4.1.7, pag. 104,
Fig. 4.2.6, pag. 116)
Connect the boards
using thr provided RF
cable kits
Connect the COM2 port
of the TSUNx to the
RS-232 port of a subrack
Connect the
subracks in a chain
using RS485 port
Are all the boards
properly inserted and
connected?
Set the Rack address (with
different addresses on different
subracks - see Fig. 4.1.7, pag. 104,
and Fig. 4.2.6, pag. 116)
Does the system
include a TSUN1 or
TSUN3 device?
Does the system
include a TSUN6
device?
Switch ON the Rack only
after having connected
the remote units
Yes
Yes
Yes
Yes
No
No
No
No
Picture A.3: Flow-chart describing the Master unit installation and cabling steps