User's Manual

5. Installing the Remote Link
EAC-2100 Manual: (Draft, 02/01) Page 5-3
5.3 Programming the Handset
The handset is programmed via its keyboard.
F NOTE: Procedure for programming the T18D to be provided later.
Once programming and initial testing is complete, the handset should have its interface
cable and RF cable connected, and then placed in the bottom of the cabinet. It should
be secured via the clamp provided.
5.4 Checking Out the Handset
After the handset has been set up and programmed, check it for proper operation by
completing the following steps.
1. With the handset connected, power up the EAC-2100. After a short while, it should
indicate that it has service.
• If the handset does not come into service, check the antenna, the antenna
connection and the mobile programming.
2. Make sure the handset can originate and answer calls in the conventional fashion.
The handset can be used to communicate with a partner while trying to optimize
the booster performance.
3. Dial the handset using another cellular phone. The handset should ring a few times,
and then answer.