User's Manual

5. Installing the Remote Link
EAC-2100 Manual: (Draft, 02/01) Page 5-2
5.1 Introduction (Continued)
The checklist in Figure 5-1 presents a brief overview of these procedures. For more
detailed descriptions of the procedures, refer to Sections 5.2−5.5.
Figure 5-1. Remote Link Installation Checklist
5.2 Setting Up Service
1. Set up service to the Ericsson T18D handset by contacting the local cellular service
supplier. Provide them with the mobile serial number.
2. Obtain from the service supplier the values for the parameters that will be
programmed into the handset.
3. Be sure the MIN of the cellular mobile has been loaded into the booster (see
Section 4.6.9).
Checklist
¨ 1. Service set up with local supplier. (Sec. 5.2)
¨ 2. T18D handset programmed: (Sec. 5.3)
¨ 3. Handset checked out for proper operation: (Sec. 5.4)
¨ a. Powering up.
¨ b. Call originating.
¨ c. Answering.
¨ 4. Remote link tested:
¨ a. EAC-2100 Answering tested. (Sec. 5.5.1)
¨ b. EAC-2100 Originating tested. (Sec. 5.5.2)