User's Manual

4. Setting Up for Initial Operation
EAC-2100 Manual: (Draft, 02/01) Page 4-25
4.7.1 Adjusting Power Levels for PAs 1−4 (Continued)
5. Set the desired power level in dBm
• If using a wattmeter, record the actual power reading (note, there may
be small differences between the entered power level and the actual
measured power level due to tolerances of the internal power reading
circuitry and the external power meter).
• The power reading at the M1 connector (for channels 1 & 2) or the
M2 connector (for channels 3 & 4) should be +40.8 ± 1 dBm (12.5
watts nominal).