User's Manual

4. Setting Up for Initial Operation
EAC-2100 Manual: (Draft, 02/01) Page 4-14
4.5.3 Setting the Donor DCCH Channel
1. From the System Parameters Menu, type B <CR> to display the
Control Channels Menu.
F NOTE: This menu represents all selections available on the Control
Channels Menu. Not all selections appear at all times. Following are
selections that are only available when used in conjunction with other
parameters:
• E - Directed Retry Channels: Appears only if selection D (DCCH
Channel State During "All Channels Busy") is set to Directed Retry.
4.5.3 Setting the Donor ControDCCH Channel (Continued)
2. Type A <CR> to access the Donor DCCH Channel parameter.
3. Enter the channel number (see Section 2.4), then <CR>.
4. To return to the Control Channels Menu, type X <CR>.
4.5.4 Setting the Boosted DCCH Channel
1. From the Control Channels Menu, type B <CR> to access the Boosted
DCCH Channel parameter. This parameter establishes the boosted DCCH
channel, to which combiner port 1 is tuned.
2. Enter the channel number (see Section 2.4), then <CR>.
4.5.5 Setting the Directed Retry Channels
1. From the Control Channels Menu, type E <CR> to access the Directed
Retry Channels parameter.
2. Enter the DCCH channel numbers of all nearby cells, including the donor.
The mobile will be directed to attempt calls on these channels when the
EAC-2100 is busy.
3. To return to the System Parameters Menu, type X <CR> twice.
DCCH Channels Menu
A Donor DCCH Channel ................................ ................................ ..................... 335
B Boosted DCCH Channel .....................................................................................340
C RF Board To Use For DCCH Channel ....................................................................1
D DCCH Channel State During "All Channels Busy" ...............DIRECTED RETRY
E Directed Retry Channels ....................................................................................LIST