User's Manual

4. Setting Up for Initial Operation
EAC-2100 Manual: (Draft, 02/01) Page 4-13
4.5.2 Entering the Site ID
1. At the > prompt, type SET <CR> to display the SET Main Menu.
2. Type C <CR> to display the System Parameters Menu.
3. Type A <CR> to display the Site ID Menu (shown below with default
values).
4. Type A <CR> to access the Site Identification parameter.
5. Enter a name (up to 20 characters) that uniquely identifies the site.
6. Type X <CR> to back out of the Site ID Menu.
Main Menu A RF Boards
B Power Amplifiers
C System Parameters
D Alarms
E Set Defaults
System Parameters Menu
A Site ID........................... Identification Multi-Hop
B DCCH Channels ...........Donor Boosted State
C DTC Channels ..............Donor Donor DVCC Boosted
D Modem Control.............Passwords Console Time-out Auto-Dial Control
Dial-up Phone Modem Mobile
E Thresholds.....................Hand-In Hand-Back Multi-Donor
Mobile Power RSSI Averaging Hand-In Delay
F Disconnect Control .......Donor RSSI DVCC Fade Time-out
Hand-Back Delay Hand-Back Attempts
G Call Processing ..............RSSI > Thresh Hand-Back / Grab-Back
Site ID Menu
Default Values
A Site Identification ................................ ................................ ......Not Assigned
B Multi-Hop Feature..........................................................................DISABLED