User's Manual

4. Setting Up for Initial Operation
EAC-2100 Manual: (Draft, 02/01) Page 4-10
4.4.2 Using the SET Menus
Configuring the EAC-2100 to fill in a coverage area in a specific cell ular
system is easy, using either the local terminal or a remote terminal. From the
command entry level (>), the SET command invokes the setup utility which
displays a progression of menus. The menus provide a guided path to each
EAC-2100 parameter. Figure 4-7 illustrates the paths to follow through the
SET menus to reach each available parameter. For descriptions of all SET
menus and commands, see Volume 2, Operating Procedures.
Moving Forward. Each command brings up a menu of items from which to
choose, with a character in front of each item. To select an item, type the
character and <CR>. The next menu (or the parameter to be changed) will be
displayed.
Moving Backward. To move backward along a path, type X <CR>, or just
<CR>. (Both entries correspond to the "Done with this menu" selection.) The
previous menu will be displayed. Continue in this manner until you have the
SET Main Menu.
Exiting. To exit SET, type <CTRL> X at any menu level. Or, type X <CR>
while at the Main Menu level.