User's Manual

4. Setting Up for Initial Operation
EAC-2100 Manual: (Draft, 02/01) Page 4-8
Figure 4-6. System Commands
Command Meaning Purpose
HEL
HELp Gives a list of the primary commands.
SET
SETup Invokes a menu-driven entry mode used to inspect or change all EAC-2100
operating parameters. (To exit this command, type <CTRL> X and answer
N <CR>.)
SSS
Show
System
Status
Gives a one-page listing of current EAC-2100 parameter settings and conditions
of monitored input parameters
SCS*
Show Call
Status
Shows current status of each board. Updates listing if status changes (e.g., if a
call is set up or taken down) and gives reason for change.
SSR*
Show
Scanned
RSSI
Shows average RSSIs of channels being scanned
RSS*
RSSI
Report
Gives a continuously updated reading of RSSIs on all RF boards.
ALA
ALArm
Report
Gives a report of the number of times various alarm conditions have occurred
since last system reset.
DCS
Display
Call
Statistics
Displays various call statistics per board (totals since last DCS=0 command).
DCH
Display
Call
History
Displays hourly totals of certain call statistics for the last running week.
TIM
TIMe Displays/changes current clock time and date.
RES
RESet Resets EAC-2100. Parameters in effect when command is issued will be
preserved.
LOC
LOCk Forces password entry before accepting subsequent commands
PWR*
PoWeR
display
Repeatedly lists power readings on all installed PAs.
DVCC*
DVCC
report
Repeatedly lists the DVCC readings on the boards
REV
REVision Displays hardware revisions in the EAC-2100
MIN*
Mobile ID
Number
Lists the last five access attempts by subscribers
* To exit this command, hit ESC or type <CTRL> Z.