User's Manual

4. Setting Up for Initial Operation
EAC-2100 Manual: (Draft, 02/01) Page 4-2
Figure 4-1. Setup Checklist
Checklist
¨ 1. Local terminal connected: (Sec. 4.2 and 4.4)
¨ a. Terminal powered up and set to 9600 baud, even parity, 7 data bits,
1 stop bit, full duplex, all capitals, send carriage return only, auto
XON/XOFF and soft scroll disabled.
¨ b. EAC-2100 powered up and password entered.
¨ 2. System status (SSS) and alarm (ALA) report checked; no disabled and no
alarms shown. (Sec. 4.6.1)
¨ 3. Site ID entered. (Sec. 4.6.2)
¨ 4. RF Channels programmed:
¨ a. Donor DCCH channel programmed. (Sec. 4.6.3)
¨ b. Boosted DCCH channel programmed. (Sec. 4.6.4)
¨ c. Donor DTC channels entered in DTC channel lists. (Sec. 4.6.5)
¨ d. Boosted DTC channels programmed. (Sec. 4.6.6)
¨ 5. Alarms and thresholds set (if desired). (Sec. 4.6.7)
¨ 6. Modem mobile MIN, mobile power step, and passwords programmed.
(Sec. 4.6.8)
¨ 7. Reverse path power level adjusted. (Sec. 4.7.3)
¨ 8. Clock set. (Sec. 4.7.4)
¨ 9. Call history, call statistics, and alarm report reset to 0: (Sec. 4.7.4)
¨ a. DCH = 0 <CR>
¨ b. DCS = 0 <CR>
¨ c. ALA = 0 <CR>