User's Manual

1900 MHz
HIGH POWER TRANSLATING CHANNEL SELECTIVE REPEATER
for TIA/EIA-136 PCS Networks
MIKOM’s EAC2100 repeater is designed to provide wide area coverage for TIA/EIA-136, 1900 MHz networks.
High power and gain, achievable due to the intelligent F1 to F2 architecture, allow the EAC2100 to provide
coverage
extension normally available only from macro-
cells. Isolation requirements are also minimized due to the translating
nature of the repeater. The repeater boosts up to four TIA/EIA-
136 carriers with channel selective RF cards. The
EAC2100’s architecture is frequency agile both on the donor and coverage channels.
The EAC2100 uses state of the art DSP technology coupled with a high speed Power PC processor to decode the
TIA/EIA-136 message stream. The EAC2100 fully supports the TIA/EIA-136 Standard and its feature set.
The EAC2100 is software configurable and remotely manageable via a modem dial up link. Call traffic statistics are
logged and reported over a rolling weekly window. All setup parameters are software settable via the local port or dial-
up link. The repeater is designed for easy installation and outdoor use.
•
Frequency Translating Channel Selective
Operation
• 2 or 4 Channel Capacity
• High Forward Output Power
• 12.5 Watts each for 4 Channels
• 25 Watts each for 2 Channels
• Multiple Cabinets for Up to 8 Channels
• Full TIA/EIA-136 Feature Set including:
• Extended Battery Life (sleep mode)
• SMS
• Calling Line and Party ID
• Over the Air Activation
• Authentication
• Registration
• Mobile Assisted Hand Off (MAHO)
• Easy Field Upgrades and Maintenance
• Receive Diversity Standard