User's Manual

3. Installing the Hardware
EAC-2100 Manual: (Draft, 02/01) Page 3-5
3.2.2.1 Mounting the Cabinet on the Pedestal
1. If using expandable anchors, determine the bolt locations (see Figure 3-4)
and drill holes in the pad.
2. Place the pedestal on the pad where it will be installed.
3. Bolt the pedestal to the pad. Be sure to orient the pedestal correctly for
RF cable entry through the ROX blocks.
4. Place the EAC-2100 on the pedestal, assemble and bolt the retaining bars
to clamp it to the pedestal.
3.2.2.2 Mounting the Cabinet on the Wall Bracket
1. Mount the wall bracket to a flat vertical surface. Make sure the bolts and the
structure into which the bolts are fastened are adequate for the weight of the
cabinet. Also, make sure the bracket is mounted high enough to allow access
to the connectors underneath the cabinet.
2. Place the EAC-2100 onto the wall bracket. If not already in place, insert two
CAP screws on upper-rear of the cabinet. Use these two CAP screws to hang
the EAC-2100 in place.
3. Secure the remaining holes in the bracket by placing screws in the appropriate
holes.
3.2.3 Securing the Door
Later, after all installation steps have been completed (including electrical
connections and initial system operation), secure the door as follows:
1. Close the cabinet door.
2. Use the key supplied to lock the upper and lower locks.
3. Place the key in a safe place for later use.
CAUTION: The EAC-2100 weighs 210 pounds (95
kg)! Use appropriate lifting aids to position the unit.
Lifting rings on the cabinet are provided for this
purpose.