User's Manual

2. Preliminary Decisions
AMPS EAC-2100 Manual: (Draft, 02/01) Page 2-4
2.3.2 AC Mains Service
The following AC mains service is required:
• 120/240 VAC
• single-phase
• 20-amp minimum service
2.3.3 Space
The EAC-2100 unit is approximately 22 in (W) x 23 in (D) x 36 in (H) (56 cm x 59 cm x 91
cm). If it is mounted on a wall bracket, allow an additional 3 in (8 cm) depth. For wall mounted
applications, it is recommended the bottom of the cabinet should be at least 12 in (31 cm) above
the ground or floor. This will allow easy access to the RF connectors that are on the bottom of
the cabinet.
If it is to be mounted on the optional pedestal, allow an additional 12 in (31 cm) to the overall
height. Approximately 3 in (8 cm) space must be provided between the rear of the cabinet and
any obstructing surface, such as a wall. This is necessary to prevent blocking the heat-
exchanger outlet vent. Also, provide enough space on of the two sides to allow access to the
antenna connectors underneath the cabinet. This access will be through one of the two filter
openings. Enough space should be provided on the other side to allow the filter to be removed
and cleaned. Six inches (15 cm) should be adequate for this purpose.
Finally, allow enough space on the front to allow the door to be fully opened (2 ft, or 60 cm
minimum).
Figure 2-2. Recommended Space
Put updated 3D drawing showing the door, the pedestal, the hanging bracket, and dimensions here.