User's Manual

Quick Start Checklist
AMPS EAC-2100 Manual: (Draft, 02/01) Page
Programming Initial Parameters (See Sections 4, 5, and 6)
1. Type SSS <CR>. (Nothing should show DISABLED. If anything shows
disabled, refer to Appendix A, Troubleshooting Guide.)
2. Type ALA <CR>. (There should be no alarms. If there are any OUT OF
SERVICE or memory alarms, refer to Appendix A.)
3. Type SET <CR> and go into submenu C, System Parameters.
4. Enter submenu A and program the site ID.
5. Enter submenu B and program the donor and boosted DCCH channels.
Decide how the DCCH control channel is to act when all channels are busy.
6. Enter submenu C and program the boosted DTC RF channel numbers for
channels 2–4.
7. Program the donor DTC RF channels into list.
8. Enter the Modem Control submenu D and program the modem mobile MIN
that has been assigned. Calls made to and from this number will not be
transferred to the booster, but will be trapped-out and handled directly by the
donor. Also set the modem mobile power step to the desired level.
9. Use <CTRL> X to exit the SET menu completely. Press <CR> at the
question prompt.
Continued . . .