Install Manual

BRITECELL System Manual MN010-04 June 2003 Page 60 of 78
The company has a policy of continuous product development and improvement and we therefore
reserve the right to vary any information quoted without prior notice.
56.4. Connectivity
There is either an N-female connector or a RG223 pigtail attached to the TPA
antenna to realise connection to the TFA.
9
WARNING: use only low loss 50 Ω RF cable to connect TPA antenna to TFA.
9
WARNING: do not connect the antenna without switching off the power supply
to the TFA.
57. Troubleshooting & maintenance
The device has no particular maintenance requirements. It is advisable to check
periodically the cable connecting the external antenna, in order to avoid any
erosion or cut which could reduce its lifetime.