Install Manual

BRITECELL System Manual MN010-04 June 2003 Page 28 of 78
The company has a policy of continuous product development and improvement and we therefore
reserve the right to vary any information quoted without prior notice.
16. Warnings
16.1. Connector care and cleaning
9
Do not leave connectors open. Unused optical connectors must always be
covered with their caps.
9
Do not touch the connector tip. Clean it with proper tissue before inserting
them into the sleeve.
If better cleaning is needed, use pure ethyl alcohol. Sleeves may be cleaned by
injecting pure gas under pressure.
9
Do not attempt to insert connectors mechanically incompatible. This will result
in severe damage.
The optical connector is a high precision device. It must be handled with care to
avoid scratches and other mechanical/optical damages that will impair or reduce
the system performance.
16.2. Laser caution
The TFA contains semiconductor lasers. Precautions should be taken when
handling, installing or servicing this equipment.
Invisible laser radiation may be emitted from the optical transmitter connector of
the TFA interface:
9
Do not stare into the beam or use optical instruments with the equipment
powered on.