User's Manual

WLS Installation and Maintenance Manual About this Document
Geometrix
®
Wireless Location System vi
Andrew Corporation Proprietary
Revision History
Version Date Issued Scope
A 07/01 Version A Released
B 10/02 Version B Released
C 06/02
Added to Section 1.3 – Figure 1-6,1-7, Tables 1-3 to 1-5
Added to Section 2.1 – Phillips #2 Screwdriver as option
to T20 Torx Screwdriver
Added to Section 2.2 – Phillips screws as option to #20
Torx Screws
Added Section 2.9 - AOA Cabling
Added Section 2.10 – AOA Antenna Cabling Procedures
Added to Section 2.11 – Comprehensive Diagnostics
D 01/03
Section 1.1 – Added figure 1-5
Section 1.3 – Changed Figure 1-5 and 6 from picture to
mech. drawing.
Section 1.4 – Added section for dual-band antenna
combiner
Section 2.1 – Updated breaker requirements
Section 2.8 – Updated table 2-2 for AOA and Combined
800/1900 MHz cabling specifications
Section 2.9 – Modified figure 2-4 for AOA configurations,
Added figures:
2-4 Power Connector Pin-out
2-5 TDOA2 Cabling
2-6 TDOA4 Cabling
2-7 AOA cabling – One Panel
2-8 AOA Cabling – Multiple Panels
2-9 TDOA mixed with AOA
2-10 for combined 800/1900 MHz WLS cabling
2-11 Noise Source – TDOA Site
2-12 Noise Source – AOA Site
Figure 4-1 AOA Calibration Test
Deleted section (2.10) on “step-by-step” AOA cabling in
preference for using diagrams.
Section 2.9 – Modified description of GSM antenna
connection.
Expanded Section 2-10 – Diagnostics and Verification
E 09/03
Andrew Corporation – name change
Revised Sections 2.10.1, 2.10.4, 2.10.7, 2.10.8 and
2.10.9 to reflect latest test screens.
Section 2.10.6 Added GPS Frequencies to Sweep
Added Figure 2-14 WLS Loopback Connector