Owner manual

7
Assembly of the appliance
1. Place the boom tube on the base of the
appliance so that the holes of the tube align
with the holes on the base of the appliance.
Screw the boom tube into the base of the
appliance using the 3 m6*10 bolts provided.
2. Fit the decorang cover over the boom
tube of the appliance.
3. Inside the middle tube is the extender tube.
Remove this from the middle tube by
rotang it and pulling it out of the middle
tube. Raise the extender tube to the height
you wish the pao head to be at and x the
middle tube and the extender tube using
the plasc xaon.
4. Place the top of the table clamp through
the circular hole and place it through the
middle pole.