Operating instructions

4
 Do not use the device when the head is lied up.
 Avoid using the product near water. When cleaning the product do
not immerse the product in water or any other liquid.
 Please read the informaon and safety advice contained in the
operang instrucons carefully and thoroughly before using the stand
mixer for the rst me.
 Make sure that the voltage shown on the rang plate corresponds
with that of the mains supply. The rang plate can be found on the
boom of the motor block. The stand mixer is only to be connected to
an AC supply (~).
 The motor must always be switched o before the stand mixer is
connected with the mains supply (switch 5 to the “0” seng).
 Do not use the product outdoors, it is for indoor use only.
 The device should not be set up in the close proximity of a heat source
i.e. naked ame, inammable materials (curtains, texles, etc.).
 Place the device as close as possible to the power source so that you
can disconnect the plug quickly and easily.
 The device must be operated with the type of power specied on the
rang label. If you are unsure about the details of the available power
supply, ask your dealer or the local power supply company.
 Do not aempt to repair the device yourself, since you will be
Appliance specic safety instrucons
extension cord is equal to or greater than the power consumpon of
the appliance to avoid overheang of the appliance and extension
cord. Do not use any other appliance on the extension cord. Do not
place the extension cord in a posion where it can be pulled on by
children or animals or be tripped over.
 Always operate the appliance on a smooth, even and stable surface.
Do not place the unit on a hot surface.
 Always remove the plug of the appliance safely. Do not pull on the
appliances cord to remove the appliances plug from the electrical
socket.
 Never handle or operate the appliance with wet hands.