User's Manual

PT-104220-EN

PRIVATE AND CONFIDENTIAL

800MHz 2x50W RRH – Installation & Operation

The 800MHz 2x50W RRH is installed by hanging and securing the RRH to a wall-mounted or pole-mounted bracket. Once

secured to the mounting bracket, connections are made to the bottom and top interfaces.

The key interfaces that must be used for normal operation are:

1)Primary CPRI input/output port (Interface 1): Connect using weatherproof optical fiber cable(fiber pair) terminated with LC

optical connectors.

2)-48VDC Input (Interface 12): Connect with 2-wire industry standard weatherproof cable. Wires are secured into UL approved

terminal block. (Gauge sized appropriately for length of cable run.)

3)Main duplex port, Tx1/Rx1 (Interface 18): Use low-loss weatherproof RF cable with 7/16DIN connector to connect this port to

base-station main antenna.

4)Diversity duplex port, Tx2/Rx2 (Interface 19): Use low-loss weatherproof RF cable with 7/16DIN connector to connect this port

to base-station diversity antenna.

Mounting Bracket

Can be mounted to wall or pole.

Pole mounting requires additional

hardware (not shown).

PAGE 1
800MHz 2x50W RRH – Installation & Operation The 800MHz 2x50W RRH is installed by hanging and securing the RRH to a wall-mounted or pole-mounted bracket. Once secured to the mounting bracket, connections are made to the bottom and top interfaces. The key interfaces that must be used for normal operation are: 1)Primary CPRI input/output port (Interface 1): Connect using weatherproof optical fiber cable(fiber pair) terminated with LC optical connectors.
PAGE 2
800MHz 2x50W RRH – FCC Label and Location FCC Statement on Label located on Right-Side of RRH heatsink fin FCC This device complies with Parts 2, 15, & 90 of the FCC Title 47 Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation.