Installation Manual

15N.m (11ft.lbs)
37N.m (27ft.lbs)
M12
Bottom Mount Installation
M10
adjust antenna angle
use inclinometer to
Adjusting Antenna Tilt
(loosen only)
M10 pivot bolt
58N.m (43ft.lbs)
(loosen only)
M10 pivot bolt
M10 bolt
(loosen only)
center location
M8 pivot bolt
M12 bolt
(remove to adjust tilt)
perimeter location
DETAIL A
M10 pivot bolt
(loosen only)
12
11
M8 adjuster bolt
13
1
910 8
14
2
MAXIMUM TORQUE
M8
MAXIMUM TORQUE
M10 37N.m (27ft.lbs)
M12 58N.m (43ft.lbs)
(Continued from page 1)
BSAMNT Mounting Kit
CommScope
ATTENTION: Insert M12 bolts and M12
flat washers into bracket with tabs
prior to attaching bracket to antenna.
M10 pivot bolt
Bulletin 639825-1 • Revision B • March 2013 Page 2 of 2
(loosen only)
International: +1-779-435-6500, Option 1
A
Customer Support Center
• Retighten all bolts.
• Reinstall adjuster bolts.
any specifications or warranties relating to Andrew products or services.
(use inclinometer)
• Adjust antenna angle.
• Remove adjuster bolts.
not remove)
Loosen pivot bolts . (do
North America: +1-800-255-1479, Option 1
Email: BSASupport@CommScope.com
Visit our Web site at www.commscope.com or contact your local sales representative for more information.
© 2012 CommScope, Inc. All rights reserved.
Andrew is a trademark of CommScope. All trademarks identified by ® or ™ are registered trademarks or trademarks,
respectively, of CommScope. This document is for planning purposes only and is not intended to modify or supplement
applicable safety precautions as shown on this page.
when the field installation is performed. Follow all
It is recommended that transmit power be turned off
results of improper or unsafe installation practices.
ladder.
is in the area. Do not use metal
day or when lightning or thunder
Do not install on a wet or windy
CommScope disclaims any liability or responsibility for the
electrocute you.
Assume any wire or line can
and guy wires look the same.
Power lines, telephone lines,
rubber gloves.
including a long-sleeved shirt and
heels. Wear protective clothing
Wear shoes with rubber soles and Do not install near power lines.
maintenance, and condition of equipment.
SAFETY NOTICE
The installation, maintenance, or removal of an antenna
requires qualified, experienced personnel. CommScope
installation instructions are written for such installation
personnel. Antenna systems should be inspected once a
year by qualified personnel to verify proper installation,
www.commscope.com/andrew
CommScope