User's Manual

RF Power Amplifiers
Andrew Corporation – Power Amplifier Group
Propriety – Use pursuant to Company Instruction
6 of 6
Installation and Operation Set-Up
The MCPA is easy to operate and use. All the require connections is located on the front
panel of the MCPA where is easy to access. The MCPA will be installed on slide-in rack
first. Make sure the DC power switch is in the OFF position, and then connect the DC
power, the communication and the RF input/output cable to the MCPA. After check the
all connection is correct and reliable, the last step is to turn on the DC power switch.
FCC Statements:
FCC ID S8L-100252MCPA
This devise complies with Part 2, 15 & 2
2 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Warning
Changes of modifications not expressly approved by the manufacturer could void the
user’s authority to operate the equipments.