Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Product
- 5 IMPORTANT SAFETY INSTRUCTIONS
- 6 Maintenance, Repair and Storage
- 7 Before Starting Work
- 8 Charging the Backpack Battery
- 9 LED Diagnostics and Acoustic Signals
- 10 Turning the Bluetooth® Interface On and Off
- 11 Assembling the Backpack Battery
- 12 Adjusting the Backpack Battery
- 13 Connecting the Backpack Battery to the Power Tool
- 14 During Operation
- 15 After Finishing Work
- 16 USB Port
- 17 Transporting
- 18 Storing
- 19 Cleaning
- 20 Inspection and Maintenance
- 21 Troubleshooting Guide
- 22 Specifications
- 23 Replacement Parts and Equipment
- 24 Disposal
- 25 Limited Warranty
- 26 Trademarks
- 27 Addresses
[SNR_Complete]
18
English
13 Connecting the Backpack Battery to the Power Tool
13.3 Connecting to a STIHL Battery-Powered
Product Designed for Use with STIHL AR L
Batteries
To connect the battery to a power tool that accepts a direct
connection of the AR L battery:
► Connect the battery as described in the power tool
instruction manual.
13.4 Disconnecting the Battery
► Switch off the power tool as described in its instruction
manual.
► If a power tool with an integrated socket is used, pull the
plug out of the power tool socket with steady, even
pressure.
► If a power tool with battery compartment is used, pull the
plug out of the AP Adapter socket with steady, even
pressure.
► If you are using power tool that accepts a direct
connection of the AR L battery: Disconnect the battery as
described in the power tool instruction manual.
NOTICE
Avoid exposing the battery to excessive heat or cold or
prolonged periods of direct sunlight. Use or storage outside
the recommended ambient temperature range can reduce
the performance and/or service life of the battery.
For further information on activating and operating the
power tool, see the instruction manual of the power tool
being operated with this battery.