Instruction Manual

[SNR_Complete]
16
English 12 Adjusting the Backpack Battery
The connecting cord can run through the guide (1) on the
shoulder strap (Illustration A), or along the back
plate (Illustration B). Secure the connecting cord to the
harness with the hook and eye fasteners (2). Always secure
the connecting cord using the guide or hook and eye
fasteners on the side of the body on which the power tool is
held and controlled. Do not allow the connecting cord to
swing across your body or hang at your side.
The length of the connecting cord can be adjusted by
making a loop around the top (Illustration C) or on the side
(Illustration D) of the backpack battery with the hook and eye
fasteners.
12.3 Putting on the Harness
WARNING
The operator must be able to remove the backpack battery
quickly in the event of an emergency. In an emergency,
open and remove the waist belt and chest strap quickly
before dropping the battery to the ground.
To ensure a proper fit:
► Put the backpack battery on your back.
► Fasten and adjust the waist belt (2) so that it rests
comfortably but securely on your hips.
► Fasten the chest strap (1) and adjust it so that it fits
comfortably but securely across your chest.
► Adjust the harness straps so that the back padding fits
snugly and securely against your back.
► Always wear the battery harness over both shoulders.
1
2
2
2
2
A B
0000-GXX-9303-A0
0000-GXX-9304-A0
C
D
1
0000-GXX-7803-A0
3
4
0000-GXX-A276-A0