Assembly Instructions

STEP 5

1.Attach the magnet (H) to the center support panel (5).

2.Insert 2 screws (M) through holes on the magnet (H) then tighten to center support panel

(5) by using a Philips screwdriver.

STEP 6

1.Insert 1 screw (K) through hole on the magnet plate (J) then tighten to door (7) by a Philips

screwdriver.

2.Attach knob (D) to door (7), insert 1 machine screw (E) through hole on the door

(7) then tighten to knob (D) by using a Philips screwdriver.

3.Insert 2 pins (G) into the holes on each end of the door (7).