Assembly Instruction

STEP 6

1.Screw in 6 cam bolts (B) into the pre-threaded holes both on left side panel (2) and right side panel (1) separately

by using a Philips screwdriver.

2.Insert 6 wood dowels (A) into dowel holes on left side panel (2) and right side panel (1) separately.

3.Attach cross bar (3) to left side panel (2) by inserting wood dowel (A) and cam bolt (B) into holes on the cross

bar(3), then insert 1 cam lock (C) into cam lock hole on the cross bar (3) and rotate clockwise to secure the cam

bolt (B) in place by using a Philips screwdriver

4.Attach bottom board (4) to left side panel (2) by inserting 2 wood dowels (A) and 2 cam bolts (B) into holes on

bottom board (4), then insert 2 cam locks (C) into cam lock holes on the bottom board (4) and rotate clockwise

to secure 2 cam bolts (B) in place by using a Philips screwdriver.

5.Attach right side panel (1) to cross bar (3) and bottom board (4) by inserting 1 wood dowel (A) & 1 cam bolt (B)

into holes on cross bar (3), and inserting 2 wood dowels (A) & 2 cam bolts (B) into holes on bottom board (4).

6.Insert 2 cam locks (C) into cam lock holes on bottom board (4) and rotate clockwise to secure 2 cam bolts (B) in

place.

7.Insert 1 cam lock (C) into cam lock hole on cross bar and rotate clockwise to secure the cam bolt (B) in place .

8.Attach the magnet (H) to cross bar (3) by inserting 2 magnet wood screws through holes on the magnet (H), then

tighten into the cross bar (3) by using a Philips screwdriver.