Digital Microscope AD206 Users Manual
LIST OF CONTENTS Safety and Maintenance............................................................................................................2 Basic Parameters.......................................................................................................................2 What’s in the box...................................................................................................................... 3 Assembly................................................................................
Safety and Maintenance 1. Please read this manual before use the microscope. If you do not follow the instructions, it‘s possible to cause the device damaged. 2. The assembly includes small parts, particularly the thumbscrews used to hold the main device in place. Do NOT allow unsupervised access by infants or toddlers. 3. The microscope is not intended for field use. It is not waterproof, and should not be exposed to extreme temperatures.
What’s in the box (P1, what’s in the box) (P2, Assembly1) (P3, 3 Assembly2)
Assembly 1. Screw the optical bracket on to the base (see the left picture above, P2 ). 2. Once you have done so, if the bracket is not aligned over the base, unscrew the locking ring, adjust the bracket’s direction, and then turn the locking ring clockwise until it is tight. (After doing this, it will still be possible to hold the base and turn the bracket if sufficient force is applied, but it will not spin freely. ) 3. Loosen the small thumbscrews on the optical bracket. 4.
(P5, remote buttons) *Frozen: Keep the image on the screen. It works at standby, record modes. *Zoom in&out: digital zooming up to 8 times. *Brightness up&down: exposure compensation from +2. 0 to -2. 0. *Line Settings: ‘十’on the remote is for net line setting. *Sharpness up&down: there are three levels of sharpness: Soft/Normal/Strong. both used to switch the levels, but in different orders. *Contrast up&down: same principle as Sharpness.
*Black & White: refer to pictures in below： Normal Black & White (P6 connect ) Quick start Connect Firstly, connect the optical stack to the power supply via the switch cable. See the picture(P6) above. Switch on Then press and hold the Power button (① from the P4 “Buttons”) underneath the display until the display turns on. (It may turn on automatically while connecting cables at the first time, and it’s totally fine.
*Troubleshooting If the display freezes, locate the “reset ” hole on the back of the monitor. Use a narrow object such as an unfolded paperclip to depress the button located inside. This resets all settings to their factory values and restarts the display. It does not erase saved images or video. Adjusting the Magnification and Focus ①Use the large knobs on the optical bracket to raise or lower the optical stack to the desired height. The lower the height, the greater the magnification is.
Delete All: deleting all unprotected images and videos; Protect: Lock Current/All: provides protection for the current/all image/video from deleting accidentally, not from Format function; Unlock Current/All: unlock the current/all image/video. Settings but In each mode, press the M button and hold it for a while until the Video/Still/Playback Menu shows up on the display(Or you can press MENU button on the remote). Hit M button again, get into the general Setup Menu.
Date/Time Press “OK” into Date/time setting. Use “Up” and “Down” to select the correct number for year/month/day. Once you finish setting a number, press “OK” on the monitor to the next number. Or, you can use “Left” and “Right” on the remote to get to the one that you want. Press “MENU” button on the remote to exit date/time setting directly. If you don’t have the remote, you have to go through all over these settings one by one and then press OK again to exit.
