Instruction Manual CERAMIC COOKTOP Model:ACHF643
Dear customer, Thank you for purchasing the ANDI ceramic cooktop. Our product can serve you many years to your satisfaction. Please read this instructions manual carefully before using and installation. Keep it in a good place after reading for future reference. Product Introduction ANDI ACHF643 microcomputer ceramic cooktop can meet different kinds of cuisine demands because of radiant heating elements, microcomputerized control and multi-power selection, really the optimal choice for modern families.
Safety Residual heat indicators After using the hob, residual heat remains in the heating area. The power display shows the code “H”, warning the heating area is still hot. Auto shut down protection During the hob use, it is shut off automatically when the default timing reach by the program if without operating. If several heating zones work simultaneously, the hob will be automatically shut off when the heating area reaches it’s default timer.
Under any circumstances, make sure the ceramic cooker hob is well ventilated and the air inlet and outlet are not blocked. Ensure the ceramic cooker hob is in good work state. As shown in Figure (2) mini 650 mm mini 5 cm mini 2 cm Air intake Figure (2) Note: The safety distance between the ceramic hob and the cupboard above the hotplate should be at least 650mm. Fix the hob on the table by screw four brackets on the bottom of hob (see picture) after installation.
Cautions 1.The ceramic cooktop must be installed by qualified personnel or technicians. Please never conduct the operation by yourself. 2. The ceramic cooker hob shall not be mounted to cooling equipment, dishwashers and rotary dryers. 3. The ceramic cooktop shall be installed such that better heat radiation can be ensured to enhance its reliability. 4. The wall and induced heating zone above the table surface shall withstand heat. 5.
The ceramic cooker hob appearance Glass plate 1 2 4 3 Control panel ON/OFF Schematic diagram of the control panel ON/OFF (1/4) Power regulating key Double zone Childproof lock key Instructions for Use Put the pot in the centre of the heating zone. Preparation before using After power on, a signal will sound, the four power indicator displays light up for 1 second then go out, indicating the ceramic cooker hob enters into standby mode.
Operation Instructions: Touch the “ON/OFF” symbol for the corresponding heating zone where there is a pot on it, and the corresponding indicator displays “-". Then you can set the heat setting by touching the “+” or “-“ symbol. ON/OFF Note: 1. In standby working mode, touch the “ON/OFF” symbol the heating zone will restore to the standby working mode if there is no heat setting within 2 minutes. 2. Every heating zone is independent each other.
Safety Reminding and Maintenance A dedicated power protection air swith protection air switch must be incorporated in the fixed wiring in accordance with the wiring rules. Never use the ceramic cooktop hob in high temperature environments such as near a gas stove or kerosene stove. Do not put any detergents or flammable materials in the equipment installed under the ceramic hob.
DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary. Indoor use only. Clean the ceramic cooker hob on a regular basis to prevent foreign matters from entering the fan thus influencing the normal operation. Cleanness and Maintenance You can easily clean the surface of the ceramic cooker hob if following the methods given in the table.
Maintenance Service Warranty For any failure of the product, please contact the customer service center. 1. There is a 3 year guarantee with this ANDI brand ceramic hob. 2. The period of warranty shall start from the date on which the invoice is issued. 3. Any one of the following cases is without the warranty: Damages caused by improper use, storage and maintenance of the consumer. Damages caused by unauthorized disassembly and repair not designated by the company.
