Operation Manual

6 7
Start and stop charging
• • With the help of the andi be free® Sicky Pad your smartphone can With the help of the andi be free® Sicky Pad your smartphone can
magnetically attach to the charger (magnetically attach to the charger (
**
).).
• • Push the bottom of your smartphone against the top of the charging head Push the bottom of your smartphone against the top of the charging head
of the andi be free® Wireless Vent Mount Charger. of the andi be free® Wireless Vent Mount Charger.
• • Now slowly lower the smartphone until you notice the strongest attraction Now slowly lower the smartphone until you notice the strongest attraction
of the magnet and then release your smartphone. The charging process of the magnet and then release your smartphone. The charging process
will start automatically and will be shown on the smartphone display.will start automatically and will be shown on the smartphone display.
• • To disconnect, remove the smartphone gently sideways from the To disconnect, remove the smartphone gently sideways from the
charging head by tilting it sideways. The charging process will be charging head by tilting it sideways. The charging process will be
interrupted automatically.interrupted automatically.
Safety Instructions
Power
Use a QC3 power plug for optimal charging results.
Never disconnect the USB power plug with wet or damp hands!
In case of malfunction while using the andi be free® device, unplug the pow-
er plug. Do not carry or pull the andi be free® product by the USB cable. The
show the same number/ millimeter. The show the same number/ millimeter. The
millimeters at the top and bottom should millimeters at the top and bottom should
also be identical.also be identical.
• • Take the Sticky Pad and remove the Take the Sticky Pad and remove the
protective lm. Hold the Sticky Pad on the protective lm. Hold the Sticky Pad on the
edge only so as not to transfer any dirt to edge only so as not to transfer any dirt to
the adhesive surface (this will aect the the adhesive surface (this will aect the
adhesive strength).adhesive strength).
• • Hold the template rmly with one hand Hold the template rmly with one hand
and check again that the template is and check again that the template is
correctly seated.correctly seated.
• • Stick the Sticky Pad into the round recess Stick the Sticky Pad into the round recess
of the template on the smartphone.of the template on the smartphone.
• • Press the Sticky Pad rmly and wait 30 Press the Sticky Pad rmly and wait 30
minutes before the rst use.minutes before the rst use.
• • Before the rst use, check the hold of the Before the rst use, check the hold of the
Sticky Pad by docking it to the charger Sticky Pad by docking it to the charger
and pulling it o gently.and pulling it o gently.