Operation Manual

4 5
Attaching the andi be free® Sticky Pad
• • To improve the adhesion of the andi be free® To improve the adhesion of the andi be free®
Sticky Pad, it is necessary to clean the back of your Sticky Pad, it is necessary to clean the back of your
smartphone or smartphone case. Please use smartphone or smartphone case. Please use
cleaning agents and accessories suitable for cleaning agents and accessories suitable for
smartphones or cases.smartphones or cases.
• • Place your smartphone (or case) with the Place your smartphone (or case) with the
display facing down on a at surface where it display facing down on a at surface where it
cannot be scratched. cannot be scratched.
• • Place the template on the back of the smartphone/case, making sure you Place the template on the back of the smartphone/case, making sure you
can read the millimeter markings on the edges of the smartphone/case can read the millimeter markings on the edges of the smartphone/case
Move the template until the millimeter readings on the right and left side Move the template until the millimeter readings on the right and left side
Connecting the Charger
• Remove the Vent Mount Charger from the package and connect the
included USB C cable to the charger head.
• Inspect the andi be free® Wireless Vent Mount Charger, as well as all
included accessories, for damage. A defective device must not be put
into operation under any circumstances.
• Check if the mechanism [1] of the hook is compatible with your venti-
lation. The hook must t through the ns.
• Insert the hooking mechanism through the ventilation grille of your car
through the lowest slat [2] and hook it.
• Turn the rotating mechanism [3] until it is xed rmly to the vent
(if you tighten it too much, the slats can break)
• By loosening the screw nut [4] behind the charging head, the charging
head can be tilted to your desired position and tightened again.
• The USB C cable needs to connected with the USB port of the car or a
power plug for the cigarette lighter.
If you use an
iPhone that
has MagSafe,
you don‘t need
an adhesive
pad or case.