Use and Care Manual

Broken Glass

In most cases, it is easier and more economical to replace the door panel, rather

than the glass. If a glass pane is broken, always cover the damaged area with

tape for safety, and cover the floors to avoid damage from falling glass. Consult

a qualified glazier or Andersen dealer.

Removing Panels

You can remove both the operating and stationary panels of

your Andersen

gliding patio door for replacement or when moving

large pieces of furniture or equipment in and out of your home.

To remove the operating panel, close and lock it, then remove

screws in the head stop (Fig. 9). Open the door and tip the

panel out from the top. Then remove it from the sill track.

• Windows and doors can be heavy. Use safe lifting techniques and a reasonable

number of people with enough strength to lift, carry and install window and

door products to avoid injury and/or product damage.

• Support operating panel in frame at all times until head stop is attached.

Failure to do so could result in the panel falling out causing injury, property

and/or product damage.

The stationary panel is secured to

the frame with screws driven into

the stationary sill filler. To remove

the stationary panel, remove these

screws (Fig. 10). Then remove the

head bracket (Fig. 11), and slide the

panel past the center of the frame.

Pull it out from the bottom.

Reinstallation instructions are provided with replacement panels. You can also

find them and a wide variety of other care and maintenance instructions at

www.andersenwindows.com.

Avoiding Trouble

Movable insulating materials — such as coverings, shutters and other shading

devices — may cause thermal stress or excessive condensation, damaging the

doors. Andersen Corporation is not responsible for product performance when

these kinds of materials or devices are used with our products.

Preventing Condensation

Most condensation problems are the result of interior atmospheric conditions,

such as humidity. For more information, ask an Andersen dealer for a copy of

the “Controlling Indoor Condensation” brochure or DVD.

GENERAL INFORMATION

Fig. 9

Fig. 10 Fig. 11