Installation Guide

9
LEFT hINGE - ExTERIOR VIEWS RIGhT hINGE - ExTERIOR VIEWS
7 - #8x1/2”
Figure 26
8. INSTALL WEAThER SEALING COMPONENTS (CONTINUED)
Tools needed:
Figure 27
1/8”
Measure from the top of the door
frame to the top of sweep n
track (Figure 26). You will use
this measurement to cut the edge
seal to its proper length.
Locate the top of the edge seal.
Measure from the top of the edge
seal and mark on the bottom of
the edge seal the measurement
that you took in Step 10.
Using the hacksaw, cut the
edge seal to its proper length
(Figure 27).
File the corners of the edge seal
until they are smooth.
Fasten the edge seal to the
door frame using the seven #8
x 1/2” color-matched screws.
(Figure 28).
10.
11.
12.
13.
14.
15.
In this step, you will install the
edge seal. Your handle set should
already be installed.
Once the edge seal is cut
to length, generously round
the bottom corner of the
edge seal with a metal le to
avoid sharp edges. Failure
to round the bottom corners
may cause an injury.
WARNING
Figure 28
Figure 26
Figure 27
2
2
6
7
Figure 28
8
6
2
8
8
6
2
2
6
7
2
8
11