Installation Guide

8
8. INSTALL WEAThER SEALING COMPONENTS
2 - #8x1/2”
INTERIOR FLOOR
In this step, you will install the
bottom sweep components.
Slide the sweep ns into the
tracks located on the bottom of
the door sweep (Figure 23).
Using scissors, trim any excess
sweep n material that extends
beyond the door sweep.
Using pliers, crimp each end
of the tracks to prevent the
sweep ns from coming out of
the tracks. See the close-up
showing the tracks as already
crimped (Figure 23).
Open the door and slide the
sweep onto the bottom of the
door frame. Make sure that the
screw slots on the sweep are
towards the interior.
Position the door sweep so that it
is ush with the latch-side of the
door frame (Figure 24).
Close the door.
From the interior, adjust the
sweep up or down until the
sweep ns come into contact
with the door sill.
Using the drill and 1/8” drill bit,
drill a starter hole into the door
using the pre-drilled hole slots as
guides.
Fasten the sweep to the door
using two (2) #8 X 1/2 color-
matched (to sweep) screws.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 23
Figure 24
Tools needed:
1/8”
7
8
8
8
2
7
LEFT hINGE - INTERIOR VIEWS RIGhT hINGE - INTERIOR VIEWS
INTERIOR FLOOR
Figure 23
Figure 24
7
8
8
8
2
7
Do not drill completely
through door. This will
create an unnecessary hole
in the door and may cause
water and air inltration.
CAUTION
12