Instructions / Assembly

ManualsBrandsAndersen ManualsDoors & Windows32 in. x 80 in. 2000 Series White Full View Storm Door

Andersen Storm Door Division is a wholly owned subsidiary of Andersen Corporation. Andersen

Storm Door Division manufactures and supports the limited warranties for Andersen® and

EMCO® storm doors. “Andersen” and “EMCO” and all other marks where denoted are trade-

for Andersen® 1-1/4” Fullview Storm Doors

Installation Guide

Please Do Not Return Product to Store!

with any questions regarding installation, lost part replacement, or anything else related to your storm door purchase.

Read this entire guide before you begin your installation. If your abilities do not

match the requirements of this installation, contact an experienced contractor.

PLEASE call the storm door Solution Center at 1-800-933-3626,

Rain Cap

Door Frame

Hinge Rail With 4 Hinges

(Hinge Side Z-bar)

Glass Panel

Side Retainers (2)

Top & Bottom Retainer (2)

Latch Rail

(Handle Side Z-bar)

Sweep

Side Screw Covers (2)

Top Screw Cover (1)

Hinge Rail Shim

Rain Cap Extender

Not Shown

Screen Shipping Clip

Installation Kit

(Pink, Clear & Green Parts

Bags Inside)

Handle Set Kit

(Blue Parts Bag Inside)

Insect Screen

Latch Side Spacer Clip

Sill Spacer Clip

PARTS OVERVIEW

Figure 1

Your installation kit should contain the following

parts. However, in some door models, not all of the

parts will be used.

Andersen SDD, PO Box 853

Des Moines, IA 50306-0853

Rev 1-2014 12088 Print in Color

p/n 621814

Summary of content (14 pages)

PAGE 1
Installation Guide U for Andersen® 1-1/4” Fullview Storm Doors Please Do Not Return Product to Store! PLEASE call the storm door Solution Center at 1-800-933-3626, with any questions regarding installation, lost part replacement, or anything else related to your storm door purchase. Read this entire guide before you begin your installation. If your abilities do not match the requirements of this installation, contact an experienced contractor.
PAGE 2
SAFETY FIRST: Please read and follow all Cautions and Warnings in this guide. warning Metal fasteners and other hardware components may corrode when exposed to preservative treated and fire-retardant treated lumber. Obtain and use the appropriate size stainless steel fasteners and hardware as called out by the installation guide to fasten unit to any rough opening made from pressure treated and fire-retardant treated lumber.
PAGE 3
2 INSTALLATION PREPARATION F interior side up lado interior hacia arriba face intérieure vers le haut i a K i b view view 2 1 F interior side up lado interior hacia arriba face intérieure vers le haut P N B In this step you will remove the insect screen and shipping clip. In this step you will install the plastic top and bottom glass panel retainers into the door frame. 1. Lay the door flat on a protected surface 1.
PAGE 4
For a Right Hand Installation, go to PageFlathead 9.
PAGE 5
! 4 ! 7/8” Machine Pan Painted Tools needed: INSTALL HINGED STORM DOOR IN OPENING (Left Hand) 5/8” A L 1/2” pink bag / BOLSA ROSA / SAC ROSE 1” SMS Pan 1 1/2” YELLOW bag / BOLSA AMARILLA / SAC JAUNE 1/2” 1/2” 5/8” N 1” 2” 1/8” x 19 1” 3/16” Plug 1 1/2” x1 1” SMS Pan Painted X a X 1” Machine Pan Painted b view ! view 5/8” 5/8” 1.
PAGE 6
5/8” 5 INSTALL LATCH RAIL and remove protective film (Left Hand) a EXterior View VISTA EXTERIOR VUE DE L’EXTÉRIEUR 1/2” 7/8” Machine Pan Painted 1/2” Tools needed: 1/2” 5/8” G 1 1/2” YELLOW bag / BOLSA AMARILLA / SAC JAUNE 1” 2” 1/8” 1” SMS Pan N 1” x6 Pad x3 1 1/2” 1” SMS Pan Painted X view X 1” Machine Pan Painted b ! ! view 1-1/2” Machine Flathead c i view #10 5/8” 1-1/2” Machine PAD Almohadilla Tampon spacer pads in the yellow bag in the installation kit. 2.
PAGE 7
#10 1” SMS Pan ! 1-1/2” Machine Flathead ! Machine Flathead 1-1/2” 1” SMS Pan Painted Tools needed: 2” SMS Pan Painted INSTALL green bag / BOLSA VERDE / SAC VERT 1” SMS Pan Painted CLOSER 2” N SMS Pan Painted 1” Machine Pan2”Painted (Left Hand) 1” Machine Pan Painted 8 5/8” 1/2” #12 1” 2” 1 1/2” #12 1/8” x1 1-1/2” Machine Flathead 5/8” SMS Pan Painted 1-1/2” Machine Flathead 5/8” SMS Pan Painted 1 1/2” x1 x3 1/2” 1/2” 5/8” i #10 #10 1-1/2” Machine Flathead a view ! 1-1/2” Machine Fla
PAGE 8
10 INSTALL SCREW COVERS (Left Hand) I J X a short leg PESTAÑA CORTA rainure courte ! 5/8” 5/8” Tools needed: view ! J J 1/2” 1/2” 1/2” Lock leg of screw cover (J) into short leg of rain cap screw track. Press on other leg to snap it into long leg of track. Make sure screw cover snaps into screw track along the entire length of the rain cap. 1” 2. Repeat this process with remaining side screw covers. 2” 1 1/2” 3. Using scissors, trim off any excess that may remain. 1.
PAGE 9
1/2” SMS Pan Painted For a Left Hand Installation, go to Page 4.
PAGE 10
! 12 INSTALL HINGED STORM DOOR IN OPENING (Right Hand) 7/8” Tools Machine Pan Painted needed: 5/8” A 1/2” pink bag / BOLSA ROSA / SAC ROSE 1” SMS Pan 1 1/2” YELLOW bag / BOLSA AMARILLA / SAC JAUNE 1/2” 1/2” 5/8” L 1” 2” N x 19 1” 1/8” 3/16” Plug 1 1/2” x1 1” SMS Pan Painted X a ! view ! R 5/8” 5/8” 1. Set the door frame on the entry sill so the hinge rail is tight against the mounting surface or hinge rail shim (K) and the sill spacer clip (R) is sitting on the door sill. 2.
PAGE 11
7/8” Machine Pan Painted 5/8” 13 install latch rail and remove protective film (Right Hand) a EXterior View VISTA EXTERIOR VUE DE L’EXTÉRIEUR 1/2” Tools needed: 1 1/2” YELLOW bag / BOLSA AMARILLA / SAC JAUNE 1/2” 1/2” 5/8” G 1” SMS Pan 1/8” 2” 1” N 1” x6 Pad x3 1 1/2” 1” SMS Pan Painted X view 1” Machine Pan Painted b ! ! X view c 1-1/2” Machine Flathead i view #10 1-1/2” Machine Flathead PAD Almohadilla Tampon 5/8” G 5/8” 1.
PAGE 12
#10 1” SMS Pan ! 1-1/2” ! Machine Flathead 1” SMS Pan Painted Tools needed: 2” SMS Pan Painted INSTALL green bag / BOLSA VERDE / SAC VERT 1” SMS Pan Painted CLOSER 2” N SMS Pan Painted 1” Machine Pan2”Painted (Right Hand) 1” Machine Pan Painted 5/8” 16 1/2” #12 1” 2” 1 1/2” #12 x1 1-1/2” Machine Flathead 5/8” SMS Pan Painted 1-1/2” Machine Flathead 5/8” SMS Pan Painted 1 1/2” 1/8” #10 i #10 1-1/2” Machine Flathead a view ! 1-1/2” Machine Flathead 2” SMS Pan Painted 2” SMS Pan Painted b oppo
PAGE 13
18 INSTALL SCREW COVERS (Right Hand) Tools needed: view J ! J short leg PESTAÑA CORTA rainure courte 5/8” 5/8” J X a ! I 1/2” 1/2” 1/2” Lock leg of screw cover (J) into short leg of rain cap screw track. Press on other leg to snap it into long leg of track. Make sure screw cover snaps into screw track along the entire length of the rain cap. 1” 2. Repeat this process with remaining side screw covers. 2” 1 1/2” 3. Using scissors, trim off any excess that may remain. 1.
PAGE 14
CLEANING INSTRUCTIONS WINDOW GLASS – The glass may be cleaned with any household glass cleaner. Keep glass cleaners away from painted parts and brass/nickel components. PLASTIC PARTS – Plastic door components may be cleaned by using a mild soap and water mixture and by gently rubbing the affected area. Do not use harsh abrasives or any product that contains chlorine. ALUMINUM PARTS – Aluminum parts on the door may be cleaned by using a mild soap and water mixture and by gently rubbing the affected area.