Instructions / Assembly

9
9. INSTALL CLOSER
Tools needed:
5/32”
4 - #10x2”
2 - #12x5/8”
In this step, you will install a jamb
bracket onto the door jamb at the
bottom (Figure 26).
Measure 5/8” below the window
opening at the bottom on the
hinge side and mark a line on the
sweep or door frame.
Extend the line onto the door
jamb.
Center the jamb bracket on this
line, placing it 1/4” behind the
hinge rail.
Using a pencil, mark each jamb
bracket hole on the door jamb.
Using the drill and 5/32” drill
bit, drill a hole in the door jamb
where you placed the marks.
Reposition the jamb bracket and
align its holes with the holes that
you drilled in the door jamb.
Fasten the jamb bracket to the
door jamb using four (4) #10 x 2”
color-matched screws.
Attach the push button closer to
the jamb bracket using the short
pin.
Attach the door bracket to the
push button closer with the long
pin.
Press the push button on the
push button closer and then pull
(extend) closer by 1/4” - 3/8”.
Close the storm door and then
center the door bracket on the
line from Step 1.
Using a pencil, mark each door
bracket hole on the door frame.
Using the drill and 5/32” drill bit,
drill a hole in the door frame
where you placed the marks.
Reposition the door bracket and
align its holes with the holes that
you drilled in the door frame.
Fasten the door bracket to
the door jamb using two (2)
#12 x 5/8” color-matched screws.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
1 -
1 -
In this step, you will install the door
bracket (Figure 28).
In this step, you will install and
pre-set the push button closer
(Figure 27).
13
13 13
77
1/4”-3/8”
LEFT hINGE - INTERIOR VIEWS RIGhT hINGE - INTERIOR VIEWS
13
13
13
13
Figure 26 Figure 26
Figure 27Figure 27
Figure 28 Figure 28
13
7
5/8”
2
3
1/4”
5
3
2
5
13
7
5/8”
1/4”
1/4”-3/8”
13