Instructions / Assembly

8
8. INSTALL WEAThER SEALING COMPONENTS
2 - #8x1/2”
INTERIOR FLOOR
In this step, you will install the
bottom sweep components.
Slide the sweep n into the track
located on the bottom of the door
sweep (Figure 24).
Using scissors, trim any excess
sweep n material that extends
beyond the door sweep.
Using pliers, crimp each end of
the track to prevent the sweep
n from coming out of the track.
See the close-up showing the
track as already crimped (Figure
24).
Open the door and slide the
sweep onto the bottom of the
door frame. Make sure that the
screw slots on the sweep are
towards the interior.
Position the door sweep so that it
is ush with the latch-side of the
door frame (Figure 25).
Close the door.
From the interior, adjust the
sweep up or down until the
sweep ns lightly come into
contact with the door sill.
Using the drill and 1/8” drill bit,
drill a starter hole into the door
using the pre-drilled hole slots as
guides.
Fasten the sweep to the door
using two (2) #8 X 1/2 color-
matched (to sweep) screws.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 24
Figure 25
Tools needed:
1/8”
7
8
8
8
2
7
LEFT hINGE - INTERIOR VIEWS RIGhT hINGE - INTERIOR VIEWS
INTERIOR FLOOR
Figure 24
Figure 25
7
8
8
8
2
7
Do not drill completely
through door. This will
create an unnecessary hole
in the door and may cause
water and air inltration.
CAUTION
11