Installation Guide

6
Tools needed:
In this step, you will install the
handle set.
Look into handle holes on door to
make sure lock case is oriented
properly. The notch in the
square spindle hole should be
facing away from the glass panel.
(Figure 16)
TIP: If the notch is not facing
away from the glass panel, use
the handle and spindle to rotate
the spindle hole into the correct
orientation
Insert handle into outside trim
plate (with Andersen logo) with
lever pointing down and rotate
the handle to secure it.
(Figure 17)
Repeat for other handle and
inside trim plate (with slider).
(Figure 18)
With handle levers held
horizontal, install both handle
assemblies onto the door. The
spindle will pass through the
square hole in the lock case and
into the other handle. Attach trim
plates together using two
#8 x 1 1/2” screws. (Figure 19)
Install lock case trim plate
onto lock case and fasten with
one #10 x 5/8” screw. Do not
overtighten (Figure 20)
Insert dead bolt key cylinder
into lock case and fasten with
one #10 x 1 1/2” screw. Do not
overtighten. (Figure 21)
NOTE: This door features an
integrated latch receiver in the
latch rail, eliminating the need
for a traditional, separate strike
plate.
1.
2.
3.
4.
5.
6.
5. INSTALL HANDLE SET
RIGHT HANDED - EXTERIOR VIEWSLEFT HANDED - EXTERIOR VIEWS
G
L
A
S
S
Figure 16
Figure 17
Figure 18
Figure 19
G
L
A
S
S
Figure 16
Figure 17
Figure 18
2- #8 x 1 1/2”
Figure 19
Figure 20 Figure 21
Figure 20
Figure 21
1- #10 x 1 1/2” 1- #10 x 5/8”
11
16
16
16
16
16
16
16
16
16
16
16
16
You can match your Andersen storm door
lock to Schlage® or Kwikset® entry door
locks. See handle set instructions contained
within handle set box for details.
“Kwikset” is a registered trademark of Newfry
LLC. “Schlage” is a registered trademark of
Schlage Lock Company.