Instructions / Assembly

7
INSTALL
HANDLE
SET &
CLOSER
(Left Hand)
IF
NECESSARY,
ADJUST THE
SWEEP
(Left Hand)
FILE EDGE
SEAL
(Left Hand)
7
8
9
1. Refer to the instructions included in the
Installation Kit (O) to drill the handle holes
and to install the door handles and closer.
Installation
Kit
O
1. Close the storm door.
2. From the interior, loosen the sweep screws
with a phillips screw driver. Adjust the
sweep (H) up or down until the sweep n
lightly comes into contact with the door sill.
3. Retighten the sweep screws.
Tools needed:
Tools needed:
a
H
i
VIEW
BOTTOM
PARTE INFERIOR
BAS
INSTALL EDGE
SEAL
(Left Hand)
10
x 6
1”
1. Open the door and remove all four hex
head screws from the edge of the door,
then properly discard screws.
1. Align rst hole down on edge seal with top
IPMFJOFEHFPGEPPSBOEJOTUBMMBwQBJOUFE
screw from yellow bag.
YELLOW BAG / BOLSA AMARILLA/ SAC JAUNE
1/8”
Tools needed:
M
M
b
X
VIEW
X
VIEW
1. File the bottom corners of the edge seal (M)
until they are smooth.
Generously round the bottom corner of the edge seal
with a metal le to avoid sharp edges. Failure to round
the bottom corners may cause an injury.
WARNING
M
a
a
X
VIEW
1. 1SFESJMMwEFFQQJMPUIPMFTJOEPPSGSBNF
through pre-drilled holes in edge seal.
2. 'BTUFOFEHFTFBMUPEPPSGSBNFVTJOHöWFw
painted screws from yellow bag.
M
M
X
VIEW
c
a
O