Instructions / Assembly

4
1. Position hinge rail along hinge-side edge of
door frame so bottom hole of the 2nd hinge
up from the bottom lines up with bottom
hole from the screws removed in step 3a.
NOTE: Top of hinge rail should extend
BQQSPYJNBUFMZwCFZPOEUPQPGEPPSGSBNF
2. 6TJOHUIFwESJMMCJUGSPNUIFQJOLCBHQSF
ESJMMwEFFQQJMPUIPMFTJOEPPSGSBNFBUFBDI
IJOHFBOEGBTUFOVTJOHwVOQBJOUFETDSFXT
from the pink bag in the installation kit.
1. Slide sweep n (I) into track in sweep (H).
Crimp both ends of track to secure the n. Trim
o excess sweep n material and properly
discard.
2. Install door sweep so it is centered across
width of door frame and pressed tight against
bottom of door frame.
3. $FOUFSQVODIBOEUIFOQSFESJMMwQJMPU
holes at the bottom of the slot for future
adjustment, then attach the sweep using
QBJOUFEwTDSFXTGSPNUIFQJOLCBH
1. Install the sill spacer clip (R) under the latch
side sweep screw and tight against the
bottom of the sweep. Tighten the sweep
screw to retain the sill spacer clip in place.
2. Install the latch side spacer clip (Q) over the
latch side of the door frame as shown. This
DMJQTIPVMECFBQQSPYJNBUFMZwGSPNUIF
bottom of the door frame.
1. Place the latch side edge of door frame on
the ground. TIP: Lay on door carton.
2. Identify the top of the hinge rail (E).
3. Remove the two middle hex head screws
from the hinge side edge of door frame.
PREPARE
STORM
DOOR FOR
INSTALLATION
(Left Hand)
3
For a Right Hand Installation, go to Page 9.
1”
x 8
x 2
1/2”
Painted
PINK BAG / BOLSA ROSA / SAC ROSE
Q
R
H
R
E
H
Q
Tools needed:
BOTTOM
PARTE INFERIOR
BAS
BOTTOM
PARTE INFERIOR
BAS
TOP
PARTE SUPERIOR
HAUT
a
d
b c
H
I
1/8”
1. Find the Installation Kit (O) located inside the door carton and identify the slot cover (S), the color
NBUDIFEwøBUIFBETDSFXTBOEUIFwESJMMCJUGPVOEJOUIFQJOLCBH
2. Do not remove the insert located inside of the hinge side pocket.
3. Hold the slot cover over the hinge side pocket of the door frame edge. Make sure hinge side
pocket is fully covered by cover plate. Mark the two mounting screw locations.
4. 6TJOHBESJMMBOEwESJMMCJUESJMMBIPMFJOUIFNBSLFEMPDBUJPOT*OTUBMMUIFTMPUDPWFSXJUIUIF
UXPwQBJOUFEøBUIFBETDSFXT
e
Installation
Kit
O
1/2”
1/8”
x 2
i
VIEW
i
VIEW
i
VIEW
i
VIEW
i
VIEW
TOP
PARTE SUPERIOR
HAUT
E
S
O
PROFILE
PERFIL
PROFIL