Instructions / Assembly

11
INSTALL LATCH
RAIL
(Right Hand)
14
G
1/8”
1”
x 3
x 6
Pad
Tools needed:
YELLOW BAG / BOLSA AMARILLA / SAC JAUNE
INSTALL THE
WINDOW
HANDLE
(Right Hand)
15
1. 'JOEUIFUISFFwTRVBSFBEIFTJWFCBDLFETQBDFSQBETJOUIFZFMMPXCBH
in the installation kit.
2. Swing door open and wipe o any residue on edge of door.
3. Peel the paper backer o each pad and attach them to the latch side
EPPSFEHF1PTJUJPOPOFBQQSPYJNBUFMZwEPXOGSPNUIFUPQPGUIFEPPS
BOPUIFSDMPTFUPUIFDFOUFSPGUIFEPPSBOEUIFUIJSEBQQSPYJNBUFMZwVQ
from the bottom.
1. Place latch rail (G) in the opening with top end pushed up against
rain cap.
2. Close storm door and slide latch rail towards door frame until it
DPOUBDUTBMMUISFFTQBDFSQBETDSFBUJOHBwHBQ
3. 6TJOHESJMMCJUBOEwTDSFXTGSPNUIFZFMMPXCBHGBTUFOMBUDISBJMUP
mounting surface.
4. Open storm door and remove spacer pads, then properly discard.
G
PAD
ALMOHADILLA
TAMPON
a b
X
VIEW
X
VIEW
If installing a door without a window handle:
1. Lower insect screen by pulling down on
orange insect screen helper tab. Once
screen is exposed, grab and hold in hand.
2. Remove helper tab by twisting and pushing
it outwards.
1. When you reach top of ventilating glass panel, a
slight pull towards you will allow insect screen pull
lip to maneuver around ventilating glass panel rail.
2. A slight push away from you will align lip and rail.
3. Raise insect screen lightly. Screen will be fully
engaged when ventilating glass panel rail is
interlocked with insect screen lip.
b
c
1
2-3
Window
Handle
P
a
1. Lower or raise the ventilating glass
panel so that the holes below the
insect screen are at a comfortable
working height.
2. If applicable, refer to the instructions
included in the Window Handle Kit (P)
to install the window handle.
i
VIEW
i
VIEW
i
VIEW
O
TAB
PESTAÑA
LANGUETTE
CUT-AWAY VIEW
VISTA TRANSVERSAL
VUE EN COUPE FRONTALE