Instructions / Assembly

ManualsBrandsAndersen ManualsDoors & Windows400 Series 36 in. x 80 in. Bronze Universal 3/4 Light Retractable Aluminum Storm Door with Nickel Hardware

1. Set the door frame on the entry sill so the

hinge rail is tight against the mounting

surface (or hinge rail shim) and the sill

spacer clip (R) is sitting on the door sill.

2. Tip the top of the door frame into the

opening, making sure that the sill spacer

clip is still on the door frame and resting on

the sill.

NOTE: Door may be out of square at this time.

INSTALL

HINGED

STORM DOOR

IN OPENING

(Right Hand)

1. The door frame is properly seated in the

opening when the hinge rail and latch side

TQBDFSDMJQ2BSFøVTIBHBJOTUUIFNPVOUJOH

surface and the mounting surface completely

lls the hole in the latch side spacer clip. If the

latch side spacer clip hole is not completely

lled, review step 2c.

2. 1SFESJMMQJMPUIPMFTVTJOHESJMMCJUUIFOVTFw

screws from yellow bag in the installation kit

to fasten hinge rail to mounting surface.

1. Open the storm door.

2. Pre-drill and fasten the hinge rail to the door

KBNCVTJOHwTDSFXTGSPNUIFZFMMPXCBH

3. Remove both orange clips from the bottom

of the door frame and properly discard.

a b c

VIEW

1”

x 19

1/8”

Tools needed:

YELLOW BAG / BOLSA AMARILLA / SAC JAUNE

3/16” Plug

x 1

1. Open the storm door. Place the rain cap (A) in the opening so that it rests on top of the hinge rail,

aligning the end of the the rain cap with the edge of the hinge rail.

2. Close the storm door. Adjust rain cap to achieve an even gap between the top of the door frame.

3. Look at the center hole of the rain cap. If the mounting surface can be seen in the entire hole,

proceed to step 13e. If mounting surface cannot be seen in the entire hole, or if there is space

above the rain cap, then remove the rain cap.

4. 'SPNUIFNPVOUJOHTVSGBDFCBDLTJEFPGUIFSBJODBQDPNQMFUFMZJOTFSUBwQMVHGSPNUIF

yellow bag into the middle hole.

5. Re-install the rain cap as described above.

1. 6TJOHUIFESJMMCJUBOEwTDSFXTGSPNUIF

yellow bag, fasten the rain cap to the

mounting surface.

2. If a plug was installed in the middle hole, you

will need to install the rain cap extender (C).

3. Place the rain cap extender over the rain cap

BTTIPXOXJUICPUIFOETCFJOHøVTI

4. 6TJOHUIFESJMMCJUBOEwTDSFXTGSPNUIF

yellow bag in the installation kit, fasten the

rain cap extender to the mounting surface.

3/16” PLUG

TAPÒN DE 0.31 CM

BOUCHON PEINT 4,8 MM

d e

VIEW