Instructions / Assembly

12
INSTALL
HANDLE SET
AND CLOSER
(Right Hand)
IF
NECESSARY,
ADJUST THE
SWEEP
(Right Hand)
FILE EDGE
SEAL
(Right Hand)
16
17
18
1. Refer to the instructions included in the
Installation Kit (O) to drill the handle holes
and to install the door handles and closer.
Installation
Kit
O
1. Close the storm door.
2. From the interior, loosen the sweep screws
with a phillips screw driver. Adjust the
sweep (H) up or down until the sweep n
lightly comes into contact with the door sill.
3. Retighten the sweep screws.
Tools needed:
Tools needed:
a
H
i
VIEW
BOTTOM
PARTE INFERIOR
BAS
INSTALL EDGE
SEAL
(Right Hand)
19
x 6
1”
1. Open the door and remove all four hex
head screws from the edge of the door,
then properly discard screws.
1. Align rst hole down on edge seal with top
IPMFJOFEHFPGEPPSBOEJOTUBMMBwQBJOUFE
screw from yellow bag.
YELLOW BAG / BOLSA AMARILLA / SAC JAUNE
1/8”
Tools needed:
M
M
b
X
VIEW
X
VIEW
1. File the bottom corners of the edge seal (M)
until they are smooth.
Generously round the bottom corner of the edge seal
with a metal le to avoid sharp edges. Failure to round
the bottom corners may cause an injury.
WARNING
M
a
a
X
VIEW
1. 1SFESJMMwEFFQQJMPUIPMFTJOEPPSGSBNF
through pre-drilled holes in edge seal.
2. 'BTUFOFEHFTFBMUPEPPSGSBNFVTJOHöWFw
painted screws from yellow bag.
M
M
X
VIEW
c
a
O