User's Manual
6
9139831
Handles must point
toward the glass with set
screw on the bottom.
Las manijas deben
apuntar hacia el vidrio
con el tornillo de jación
en la parte inferior.
Slide handles and bushings together tightly. Insert set screw in exterior handle and tighten using hex key. Finish tightening escutcheon bolts.
Slide handles and bushings together tightly. Insert set screw in exterior handle and tighten using hex key. Finish tightening escutcheon bolts.
Position interior escutcheon on panel as shown and fasten bolts (do not fully tighten until handles have been installed).
Position interior escutcheon on panel as shown and fasten bolts (do not fully tighten until handles have been installed).
9
Interior
Loosen set screw on handle and remove spindle. Replace existing spindle with 4-1/4"spindle and tighten set screw. Set screw must enter v-slot in
spindle when securing the handle.
Loosen set screw on handle and remove spindle. Replace existing spindle with extended spindle and tighten set screw. Set screw must enter v-slot in
spindle when securing the handle.
Escutcheon
Bolt
Perno de
escudete
Interior Active
Escutcheon
Escudete con
apertura interior
10
Interior
Spindle
Husillo
Exterior Handle
Manija exterior
Interior Handle
Manija interior
Set Screw
Tornillo de
jación
Hex Key
Hex Key
Bushing
Casquillo
Bushing
Casquillo
Line up v-slot
with set screw
Alinee la ranura
en forma de V
con el tornillo de
fijación
Spindle (V-Slot)
Husillo (ranura en
forma de V)
Set Screw
Tornillo de jación
11
Interior
Bottom View/
Vista inferior
Spindle
Husillo
Tribeca
®
Hardware Only
Tribeca
®
Hardware Only
Replace existing bolts
with #8 x 1-3/4" bolts.
Replace existing bolts
with #8 x 1-3/4" bolts.
#8 x 1-3/4" Bolt
#8 x 1-3/4" Bolt
Hex Key
Hex Key
4-1/4" Spindle
4-1/4" Spindle
Existing Spindle
Existing Spindle