User's Manual

4
9142195
9
Interior
Retract tilt latches by pushing lock handle(s) outward. Tilt bottom sash in and support.
Retract tilt latches by pushing lock handle(s) outward. Tilt bottom sash in and support.
8
Interior
For Units with Two Locks Only / For Units with Two Locks Only
Remove screws from left lock and dispose of properly. Do not remove lock. Position VeriLock dummy cover around left lock and fasten using #8 x 1"
color matched screws provided. Do not over tighten screws.
Remove screws from left lock and dispose of properly. Do not remove lock. Position VeriLock dummy cover around left lock and fasten using #8 x 1"
color matched screws provided. Do not over tighten screws.
VeriLock Dummy Cover
VeriLock Dummy Cover
10
Interior
Clean area on keeper to receive magnet with cleaning wipe provided. Remove adhesive liner and position keeper magnet as shown. Press firmly in place.
Clean area on keeper to receive magnet with cleaning wipe provided. Remove adhesive liner and position keeper magnet as shown. Press firmly in place.
Keeper Magnet
Keeper Magnet
Adhesive Liner
Adhesive Liner
Keeper
Keeper
NOTE: Magnet is
installed on the right
keeper of units with
two locks, as viewed
from the interior.
NOTE: Magnet is
installed on the right
keeper of units with
two locks, as viewed
from the interior.
NOTE: Set window on
a support object at
an angle greater than
100 degrees.
NOTE: Set window on
a support object at
an angle greater than
100 degrees.
>100º