Instructions / Assembly

9
TROUBLESHOOTING
(Left Hand)
For additional help with these,
or any other installation steps,
please call our Solution Center
at 1-800-933-3626.
10
If your bottom spacer falls o or is
out of position prior to fastening the
door the the mounting surface:
1. Hook the clip on to the sweep.
2. Rotate clip until it snaps over back
of sweep.
3. Slide clip until it is touching sweep
screw on handle side of door.
If handle binds or doesn’t spring back:
1. Slightly loosen key cylinder and lockcase
plate screws (A).
2. Test handle set. If handle moves freely,
you’re done.
3. If it still binds: Slightly loosen trim plate
screws (B).
4. If it still binds again: Slightly loosen lock
case screws (C).
If door isn’t latching onto latch rail:
1. Remove screw cover from latch rail (if installed).
2. Remove six 1” screws from latch rail.
3. Push latch rail toward door frame until latch falls into
opening in latch rail.
4. If you can see holes in mounting surface through holes
in latch rail, you will need to drill new holes in latch rail.
Use 1/8” drill bit to drill holes 1” above or below existing
holes.
5. Fasten latch rail to mounting surface using six 1” screws.
6. Reinstall screw cover (see step 5c).
b
ca
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
1/8”
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
Tools needed:
X
VIEW
B
A
C
H
Tools needed:
FILE
EDGE
SEAL
(Left Hand)
9
Generously round the bottom corner of the edge seal with a metal le to avoid sharp
edges. Failure to round the bottom corners may cause an injury.
WARNING
1. File the
bottom
corner
of the
edge seal
until it’s
smooth.
a
EDGE SEAL
JOINT DE REBORD
SELLO DEL BORDE
BOTTOM
PARTE INFERIOR
BAS
X
VIEW
E
a
1. Open the door and then let it close.
Note the speed at which the door
closes.
2. Using a Phillips head screwdriver to
adjust the closer to the desired speed:
For a faster closing speed, turn
the adjustment screw to the left
(counterclockwise).
For a slower closing speed, turn
the adjustment screw to the right
(clockwise).
3. Test the speed at which the door closes
after each adjustment. Adjust the screw
more, if needed, to achieve the desired
door closing speed.
ADJUST
CLOSING
SPEED OF
DOOR
Closer and door shown
are for reference only.
8
Tools needed:
Storm door will close more quickly when entry door is open. To achieve the proper
closing speed, you will need to adjust the closer(s) using the built-in adjustment screw.
Check for safe closing speed with your entry door in both the closed and the open
position. To prevent injury, make sure people and/or pets are completely through the
opening before allowing the storm door to shut freely.
WARNING
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
i
VIEW