Instructions / Assembly

5
You can match your Andersen storm door lock to Schlage® or Kwikset®
entry door locks. See handle set instructions contained within handle set
box for details.
“Kwikset” is a registered trademark of Newfry LLC. “Schlage” is a registered
trademark of Schlage Lock Company.
1. Starting at the mitered corners, remove the
clear protective tape from both the interior
and exterior of door frame, if applicable.
1. Install lock case trim plate onto lock case and
fasten with one 5/8” screw. Do not overtighten.
2. Insert dead bolt key cylinder into lock case and
fasten with one 1 1/2” athead screw. Do not
overtighten.
NOTE: This door features an integrated latch
receiver in the latch rail, eliminating the need for a
traditional, separate strike plate.
1. Insert handle into outside trim plate (with
Andersen logo) with lever pointing down
and rotate handle 180 to secure it.
2. Repeat for other handle and inside trim
plate (with slider).
3. NOTE: Trim plates should not be installed
on the door while completing above steps.
1. Rotate handle levers into a vertical position.
2. Install both handle assemblies onto door.
Spindle will pass through square hole in
lock case and into other handle.
3. Rotate handles to a horizontal position.
4. Attach trim plates together using two 1-1/2”
pan head screws.
REMOVE
PROTECTIVE
TAPE AND
INSTALL
HANDLE SET
(Left Hand)
4
d
a
c
L
5/8”
1-1/2”
x 2
1-1/2”
!
!
1/2” 1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
b
1
2
1
1
2
2
#8
#10
#12
#6
3/4” Machine Pan Painted
1/2” SMS Pan
1/2” SMS Pan Painted
1/2” SMS Flathead
1/2” Self-Drill Pan
1/2” Self-Drill Pan Painted
3/4” Machine Flathead
7/8” Machine Pan Painted
1” SMS Pan
1” SMS Pan Painted
1” Machine Pan Painted
1-1/2” Machine Flathead
1-1/2” Machine Flathead
2” SMS Pan Painted
5/8” SMS Pan Painted
1-1/4” SMS Pan
#8
#10
#12
#6
3/4” Machine Pan Painted
1/2” SMS Pan
1/2” SMS Pan Painted
1/2” SMS Flathead
1/2” Self-Drill Pan
1/2” Self-Drill Pan Painted
3/4” Machine Flathead
7/8” Machine Pan Painted
1” SMS Pan
1” SMS Pan Painted
1” Machine Pan Painted
1-1/2” Machine Flathead
1-1/2” Machine Flathead
2” SMS Pan Painted
5/8” SMS Pan Painted
1-1/4” SMS Pan
#8
#10
#12
#6
3/4” Machine Pan Painted
1/2” SMS Pan
1/2” SMS Pan Painted
1/2” SMS Flathead
1/2” Self-Drill Pan
1/2” Self-Drill Pan Painted
3/4” Machine Flathead
7/8” Machine Pan Painted
1” SMS Pan
1” SMS Pan Painted
1” Machine Pan Painted
1-1/2” Machine Flathead
1-1/2” Machine Flathead
2” SMS Pan Painted
5/8” SMS Pan Painted
1-1/4” SMS Pan
i
VIEW
i
VIEW
3