Instructions / Assembly

3
INSTALLATION
PREPARATION
2
a
b
1. Most homeowners prefer to have the storm
door handle on the same side as the entry door
handle. In shallow door openings, this can cause
the two handles to interfere. Check for potential
interference using the rough measurements. If you
anticipate that there will be interference, purchase
a storm door that is hinged on the opposite side of
your entry door. See page 2, Figure 3 for detailed
hardware depth requirements.
1. To remove the glass panel (I), rst reach under the
side of the door frame near the handle holes and
gently push up on glass panel until you are able to
rmly grasp onto it.
2. While maintaining a rm grip on glass panel,
gently lay door frame back down. Pull glass panel
away from opposite side of door frame and then
lift it out of door frame and set aside.
3. Stand glass panel on its edge to prevent damage.
1. Lay the door at on a protected surface with the exterior side down.
TIP: Lay on door carton.
2. Remove insect screen (N) by pressing down on the shipping clip to release insect screen.
3. Remove the shipping clip using a pair of pliers. Grasp shipping clip and pull out of door
frame. Properly dispose of shipping clip.
In this step, you will conrm that your storm door hinges on the correct side.
1. Left Handed (Figure 4): From the exterior, a left handed storm door will have the handle on
the left side of the storm door. See pages 4-9 for installation instructions.
2. Right Handed (Figure 5): From the exterior, a right handed storm door will have the handle
on the right side of the storm door. See pages 10-15 for installation instructions.
Figure 4 Figure 5
2 1/2”
40 1/2”
c
d
Tools needed:
LEFT HANDED
A LA IZQUIERDA
À MAIN GAUCHE
RIGHT HANDED
A LA DERECHA
À MAIN DROITE
X
VIEW
TO DOOR SILL
HASTA EL BATIENTE DE LA PUERTA
JUSQU’AU SEUIL DE LA PORTE
!
!
1/2”
1/2”
1/2”
1”
1 1/2”
2”
1 1/2”
5/8”
5/8”
2
1
3
N
I