Installation Guide

5
PLACE AND
FASTEN SILL
ADAPTER
Tools Recommended:
a1 Thoroughly clean the Door Sill.
a2 From the interior of screen assembly, position Sill Adapter with the
textured side up and screw holes in toward the interior of the home.
a3 Insert edge of the Sill Adapter into the Adapter Channel located on
the Screen Track (see Figure 1).
a4 Rotate the Sill Adapter down to the Door Sill (see Figure 2).
a5 Center the Sill Adapter in the door opening.*
b1 With ⁄" bit provided, predrill through the three holes on the Sill Adapter
into the Door Sill a maximum depth of ¼".
b2 Lift Sill Adapter and apply sealant into predrilled holes until sealant
over-ows onto Door Sill surface.
b3 Rotate the Sill Adapter back down to the Door Sill and fasten using
three #8 - ½" Self-Tapping Screws. Cleanup excess sealant.
* 30.5” sill adapter is designed to avoid the need for cutting during installation.
If a wider sill adapter is preferred, visit parts.andersenstormdoors.com
e From the interior of the screen assembly, hold the Screen Housing side
Screw Flange against the Mounting Surface, extend the insect screen
across the assembly and latch. Orange Installation Clips can come o
and be properly disposed of.
f1 Verify the screen assembly is plum, level and square in the door opening
and the Screen Housing side Screw Flange is tight to Mounting Surface.
f2 With ⁄" bit provided, predrill through the three holes on the Screen Housing
side Screw Flange into the Mounting Surface a maximum depth of ¾".
f3 With the three remaining #8 - 1" screws, fasten Screen Housing
to the Mounting Surface. (Be careful not to over tighten)
b
SCREW PACK
#8 - ½"
(Qty 3)
#8
#10
#12
#6
3/4” Machine Pan Painted
1/2” SMS Pan
1/2” SMS Pan Painted
1/2” SMS Flathead
1/2” Self-Drill Pan
1/2” Self-Drill Pan Painted
3/4” Machine Flathead
7/8” Machine Pan Painted
1” SMS Pan
1” SMS Pan Painted
1” Machine Pan Painted
1-1/2” Machine Flathead
1-1/2” Machine Flathead
2” SMS Pan Painted
5/8” SMS Pan Painted
1-1/4” SMS Pan
SCREEN
TRACK
SILL
ADAPTER
SILL
ADAPTER
SILL
ADAPTER
DOOR
SILL
DOOR
SILL
DOOR
SILL
ADAPTER
CHANNEL
ADAPTER
CHANNEL
SILL
ADAPTER
#8  ½ "
SCREW
SILL
ADAPTER
DOOR
SILL
DOOR
SILL
3
Sill Adapter
e f
LATCH
MOUNTING
SURFACE
MOUNTING
SURFACE
SCREW
FLANGE
SCREW
FLANGE
#8  1"
SCREW
SCREEN
HOUSING
SCREEN
HOUSING
a
Figure 1 Figure 2
2 PLACE AND FASTEN ASSEMBLY - Continued
MAX ¼"
DEPTH
Drill
Sealant
#2 Phillips Bit
(provided)
1/8 Drill Bit
(provided)
Soft Cloth