Measurement Guide
W1
VERIFY MOUNTING SURFACE REQUIREMENTS AND MEASURE DOOR OPENING
UNIVERSAL HANDING
Verify that the exterior brickmould, trim board or casing (exterior trim) is rmly attached to the
opening structure and is a material that is suitable to suciently fasten the retractable insect
screen to the door opening. The performance of the retractable insect screen could be
eected over time if it is not suciently fastened to the opening.
LuminAire is designed to work for left and right handed
door openings simply by rotating the unit to the correct
operating orientation.
Measurement Guide
for Andersen® LuminAire
®
Retractable Insect Screen Double Door
with SlideAway® Insect Screen System designed for 68" to 72" wide openings
Emco Enterprises, Inc., is a wholly owned subsidiary of Andersen Corporation. Emco Enterprises, Inc. manufactures
and supports the limited warranties for Andersen
®
and EMCO
®
doors. “Andersen”, “EMCO” and all other marks
where denoted are trademarks of Andersen Corporation. ©2019 Andersen Corporation. All rights reserved.
If the Door Sill doesn’t extend past the Mounting Surface or doesn’t
have sucient support, product damage, injury or both may occur.
•
If the Door Sill extends past your exterior trim Mounting Surface
and is supported, no modication is required (see Figure 3a).
•
If the Door Sill is extended without support or not extended (see Figure 3b),
you will need to add support blocking. See Installation Guide for details.
CAUTION
To install the retractable insect screen door, you must verify that
the opening width, height and mounting surface are suitable
size to properly install into the opening.
1. Measure the width at the top (W1), middle (W2), and bottom (W3)
of the opening (see Figure 1). Measure from the inside of the exterior
trim. Utilizing the narrowest width, reference chart below.
2. Measure the height at the center of the opening, from the bottom
of the exterior trim at the top of opening down to the sill at the
bottom of opening. Reference chart for height compliance.
Configuration Widths
(Adjustable Widths)
Opening Widths
(Configuration Ranges)
Opening Heights
72 Configuration 70" – 72"
80" (80" – 80 ⁄")
68 Configuration 68" – 69 ⁄" Also Available in
Requires Cutting Less than 68"
78" (78"–78 ⁄") or 84" (84"– 84 ⁄")
3. Make sure that the exterior trim meets the mounting surface
requirements to accommodate the retractable insect screen
assembly (see Figure 2). The assembly needs 3/4" at surface
on exterior trim face and 3/4" minimum depth of mounting surface.
Figure 1
W3
H
W2
Figure 2
3/4" MIN
DEPTH
3/4" MIN FLAT
SURFACE ON FACE
Figure 3a
No Modication Required Blocking Required
Figure 3b
MOUNTING
SURFACE
MOUNTING
SURFACE
DOOR
SILL
DOOR
SILL
OR