Instruction Manual

SET UP DEHUMIDIFIER FOR INSTALLATION

IMPORTANT: Cut the strap securing the compressor shipping support

bracket and remove the strap and shipping bracket. See FIGURE 1.

PACKAGING CONTENT

1. Dehumidifier

2. Inlet/Outlet Collars

3. Installation and Operating Insttructions

4. Parts Bag

a. #10 x 1/2 Screws (9)

b. Threaded Barbed Fitting for Drain Connections

c. Torx Bit

5. 10 Foot, 3/4" Drain Tube

DUCT COLLARS

If suspending the unit over the canopy but not ducting the unit, no duct collars are needed (see FIGURE 2). If ductwork will be installed to a

suspended unit, attach the inlet and outlet duct collars as shown in FIGURE 3. If placing the unit on the floor, no duct collars are necessary.

CLIP OFF

PLASTIC

STRAP

REMOVE SHIPPING BRACKET

OUTLET

DUCT

COLLAR

INLET

DUCT

COLLAR

90-2302

90-2308 90-2308

FIGURE 1 – REMOVE SHIPPING BRACKET

FIGURE 2 – HANGING OR FLOOR MOUNT FIGURE 3 – HANGING INSTALL WITH DUCTING